24/7 Emergency HVAC Available
(647) 280-6626
Furnace Maintenance · $150 + HST Flat Rate

Furnace Tune-Up in Mississauga

A furnace tune-up in Mississauga for $150 + HST. We clean the parts that cause most winter breakdowns, test the safety controls and check for carbon monoxide. You get a written note of what we found, and nothing extra is done without your yes.

$150 + HST
Flat price for the tune-up
CO & Safety Tests
On every single visit
Licensed Gas Fitter
TSSA work done in-house
★ 5.0 on Google
181 verified reviews
RD Website — Service Request24/7 Monitored

Book a Furnace Tune-Up

Send the details and Real Deal HVAC staff will follow up to confirm your window.

Staff review and confirm your exact window. Price agreed in writing before any work begins.

The Checklist

What We Do on a Furnace Tune-Up

Every tune-up follows the exact same checklist, so nothing gets skipped.

1

Safety & Combustion

  • Test for carbon monoxide (CO) around the furnace and living areas
  • Inspect the heat exchanger for hairline cracks (prevents flue gas exhaust from entering household air)
  • Test high-limit switch, rollout sensors, and pressure switch safety shutoffs
2

Burners & Ignition

  • Clean burners and verify steady, clean blue flame pattern
  • Clean and polish the flame sensor — the #1 cause of furnaces starting then shutting off within 5 seconds
  • Test hot surface igniter electrical resistance against manufacturer specifications
3

Gas Pressure, Venting & Drainage

  • Meter gas manifold pressure against factory data plate spec
  • Inspect exhaust flue and PVC vent pipes for rust, disconnected joints, or exterior blockage
  • Flush and clear condensate drain lines and trap on high-efficiency condensing units
4

Airflow, Motor & Electrical

  • Inspect air filter and verify proper airflow direction (replace if needed)
  • Clean blower wheel assembly and measure supply-to-return temperature rise
  • Tighten electrical connections, test blower motor capacitor microfarads, inspect control board
  • Calibrate and test thermostat cycle start and stop sequence
High efficiency gas furnace in a basement with its front panel closed
High-efficiency gas furnace inspection in Mississauga. TSSA licensed gas technician checking draft inducer, flame sensor, and manifold gas pressure.
Transparent Add-On PricingFull Catalog →
Furnace tune-up (one unit)Flat rate full checklist$150 + HST
Duct cleaning, whole homeHigh-power negative vacuumFrom $475 + HST
Aprilaire 500 humidifier installedWhole-home moisture balance$650 + HST
Ecobee smart thermostat installedWi-Fi setup & C-wire included$350 + HST
All from our published pricing list. Add any of these to your tune-up visit with no duplicate trip charges.
Upfront Pricing

Furnace Tune-Up Price: $150 + HST

A furnace tune-up is a flat $150 + HST. That covers the full checklist on one furnace.

If we find a worn part during the visit, here is exactly what happens:

  • We show you the part and clearly explain what it does
  • We tell you if it needs fixing now or can safely wait until spring
  • You get the exact repair price in writing before anything is touched
  • Nothing is replaced unless you say yes — no surprise bills ever

Have two furnaces? Larger homes often run two separate systems. Each one receives the full checklist. Please mention this when requesting service so we can allocate sufficient time and confirm pricing for both before dispatch.

Why Fall & Early Winter

Why Book Your Tune-Up Before Deep Cold Sets In

It is late in the season, but never too late. Here is why the timing matters.

1

Furnaces Fail Under Load

Weak igniters and dirty flame sensors hold on during mild fall weather. They give out when the furnace runs continuously for hours on a sub-zero January night.

2

It Is Cheaper Now

A worn part found during a tune-up is a scheduled, daytime repair. The same part failing at midnight in a deep freeze becomes an urgent emergency no-heat call.

3

Manufacturer Warranty Records

Most furnace manufacturers (Keeprite, York, Carrier, Lennox) require proof of yearly professional maintenance to keep 10-year parts warranties valid. Your written tune-up note is that record.

Get your furnace ready for winter.

Call or send the form to book your $150 + HST tune-up. Price agreed in writing.

Furnace Cleaning

Furnace Tune-Up or Duct Cleaning?

People search for “furnace cleaning” and mean one of two different jobs. They clean entirely different parts of your HVAC system.

ComparisonFurnace Tune-UpDuct Cleaning
What gets cleanedBurners, flame sensor, blower wheel, condensate drainEvery supply and return duct trunk, plus blower compartment
Main goalSafe, reliable winter heatLess household dust & pet dander
Safety tests includedYes: CO test, gas pressure & safetiesNo
Recommended frequencyEvery year (fall)Every 3–5 years, or after home renovations
Price$150 + HST flatFrom $475 + HST flat
Steady blue flame on a gas burner inside a high efficiency furnace
Clean gas combustion showing steady, sharp blue flames after burner servicing. Yellow or lazy flames indicate soot, restricted oxygen, or improper gas pressure.

Rather not remember?

A maintenance plan books your furnace and AC visits before each season, so your tune-up happens on time every year automatically.

Winter Ready

Your Part: A Winter Readiness Checklist

Between tune-ups, these safe homeowner tasks keep the furnace running smoothly all winter. (No gas or electrical disassembly required.)

Change the air filter

Replace your 1-inch filter when turning the heat on, then inspect it monthly. A clogged filter is the #1 cause of limit switches tripping on high temperature.

Test carbon monoxide alarms

Press the test button on every CO detector on each floor. Replace batteries annually and replace detectors past their 7-10 year lifespan.

Clear furnace clearance space

Keep a 3-foot perimeter around your furnace clear of storage boxes, paint cans, laundry, and flammable items.

Clear outdoor vent pipes

After heavy snowstorms, check the white PVC intake and exhaust pipes on the side of your home to confirm they are not buried in snow or ice.

Switch thermostat mode early

Test Heat mode on a mild October afternoon to confirm the burners ignite before the first freezing night of the season.

Check humidifier water pad

If you have an Aprilaire or bypass humidifier attached to the furnace, install a fresh water evaporator pad and open the seasonal duct damper.

Want a deeper walkthrough? Read our detailed Ontario homeowner maintenance guide.Read Furnace Maintenance Checklist for Ontario →
Where We Go

Furnace Tune-Ups Across Mississauga & Peel Region

We tune up furnaces all over Mississauga, and in Oakville, Etobicoke, Burlington, and Milton. Many homes in Erindale, Streetsville, Churchill Meadows, Erin Mills, and Clarkson run furnaces installed 15 or more years ago. A yearly tune-up on an older furnace shows you how much life it has left, so a replacement can be planned instead of rushed. When the time comes, our furnace installation page lists full installed pricing.

FAQ

Furnace Tune-Up FAQs

How much is a furnace tune-up in Mississauga?

A furnace tune-up is a flat $150 + HST for one residential furnace. That covers the complete 4-part checklist on this page, including CO test, burner cleaning, and safety checks. Any worn part we discover is priced in writing first, and is only repaired if you approve.

Is it too late for a furnace tune-up in November or December?

No. Early fall before first cold weather is ideal, but a tune-up at any point before or during deep winter catches weak parts before extreme sub-zero weather stresses them. It is far better done late than skipped.

Does a furnace tune-up clean the home's ducts?

No. A furnace tune-up cleans and calibrates the mechanical components inside the furnace cabinet (burners, flame sensor, blower wheel, drain trap). Duct cleaning is a separate whole-home service that cleans the supply and return trunk lines through your house. Both can be combined on a single visit.

Do you test for carbon monoxide during the tune-up?

Yes. We test for carbon monoxide around the furnace cabinet and inspect the heat exchanger for cracks on every visit. If your household CO detector ever alarms, evacuate everyone outside immediately and call 911 or Enbridge from outdoors.

Does a brand new furnace still need a yearly tune-up?

Yes. Condensate drains, flame sensors, and blower fans still accumulate debris on newer units. Most major equipment manufacturers also require documented annual professional maintenance to keep the 10-year parts warranty active.

Will a furnace tune-up lower my gas heating bill?

It helps efficiency by cleaning restricted burners and blowers and verifying correct manifold gas pressure. However, the biggest benefits are safety (CO prevention) and reliability — preventing a zero-heat emergency in the middle of a January freeze.

Will you try to sell me unneeded parts during the visit?

No. We show you the exact component, explain what it does, and give you an honest appraisal of whether it needs service now or can wait until spring. You get the repair price in writing, and you decide. Many tune-ups end with nothing needing repair.

Can you tune up two furnaces during one visit?

Yes. Larger homes or multi-zone residences often have two separate furnaces. Each unit receives the full checklist. Please mention this when booking so we allocate enough time and confirm pricing for both before dispatch.

Is an annual maintenance plan better than booking single tune-ups?

A maintenance plan suits homeowners who prefer not to remember seasonal maintenance — we contact you to schedule furnace visits in fall and AC visits in spring. If you prefer booking on your own each year, the $150 flat visit works equally well.