Tank Water Heater Repair in Mississauga
Fast diagnosis for no hot water, leaking tanks, pilot out, rumbling noises, and discoloured water. We service Bradford White, GE, Rheem, and John Wood across Mississauga, Oakville, Etobicoke & Burlington.
Book Water Heater Repair
Describe the symptom (no hot water, leak, noise). Staff will confirm.
Common Tank Water Heater Problems
We service all major gas and electric tank brands including Bradford White, GE, Rheem, John Wood, and A.O. Smith:
No Hot Water
Pilot light out, failed thermocouple, bad gas control valve, or a tripped ECO (energy cut-off) safety switch. We diagnose the ignition chain and restore hot water.
Leaking Tank
Internal glass lining failure, corroded anode rod, or a leaking drain valve. A tank leaking from the bottom is at end-of-life and needs replacement — we confirm before any repair.
Not Enough Hot Water
Dip tube degradation, sediment buildup reducing capacity, undersized tank for household demand, or a faulty thermostat mixing valve. We flush, inspect, and size correctly.
Pilot Keeps Going Out
A weak thermocouple, a dirty pilot orifice, drafty venting, or condensation extinguishing the pilot. We replace the thermocouple and clean the assembly.
Strange Rumbling or Popping
Sediment buildup at the tank bottom traps water against the burner, causing miniature steam explosions. A flush and anode rod inspection usually resolves it.
Discoloured or Smelly Water
A corroded anode rod or bacteria growth inside the tank. We flush the tank, replace the anode rod, and shock-treat if bacteria is present.
Tank leaking or no hot water right now?
Phone answered 24/7. Same-day appointments available when scheduling allows.
Repair vs. Replacement
Repair When
- Tank is under 8 years old
- Single component failure (thermocouple, valve, anode rod)
- No visible leaks from the tank body
Replace When
- Tank is leaking from the bottom (glass lining failed)
- Tank is over 10 years old with multiple repairs
- Repair cost exceeds 40% of replacement ($780+)
Tank Water Heater Repair FAQs
How much does a water heater repair diagnostic cost?
A tank water heater diagnostic is $165 + HST. The visit identifies what failed, whether repair or replacement makes more sense, and the repair price is agreed in writing before any work begins.
Why is my hot water tank leaking from the bottom?
A bottom leak usually means the glass lining has failed and the steel tank is corroded through. This is not repairable — the tank must be replaced. We confirm this before charging you for any repair work.
How long does a water heater repair take?
Most common repairs (thermocouple, pilot assembly, gas control valve, drain valve) are completed the same visit. Tank flushing takes 30-45 minutes. Full replacements are typically done in 2-3 hours.
Should I repair or replace my water heater?
If the tank is under 8 years old and the repair is a single component (thermocouple, valve, anode rod), repair is cost-effective. If the tank is leaking, over 10 years old, or needs multiple repairs, replacement from $1,950 + HST is the better value.
What brands of water heaters do you repair?
We service Bradford White, GE, Rheem, John Wood, A.O. Smith, and most major gas and electric tank brands. We carry common replacement parts on the truck for fast same-visit fixes.
How often should I flush my water heater?
Annual flushing removes sediment that causes rumbling, reduces capacity, and shortens tank life. In areas with hard Mississauga water, flushing every 6-12 months is recommended.
